This is the AC fan's plug. I cut in here to bring the hot wire
over from the motor fan. |
Here's the hot wire on the motor fan side. |
I slit it with a single edge razor blade...BE CAREFUL! |
The tap is made...soldered of course. You only need the hot wire. |
I put a connector at the other end, just where I hooked up to the AC side. This is necessary for removing the fans to work on the front of the engine. |
Crimping is great. It holds the wire so you can solder it! ;-) |
There, ALL DONE! NOTE: Do NOT re-hook up the
original secondary fan's hot wire. It goes to ground when
the AC is off and will short out your fuse. |
Test the fans by jumping GND and TFA in the diagnostic box. They should BOTH come on. |
BTW here is a great place to store your paper clip. You know you've run into a real miataphile when they see it under the hood and go,
"Hey that's a great place to store that jumper!" ;-) |